The quadcopter : the flight controller shield

For our new quadcopter frame(article coming soon 😉 ), we decided to create a completely new Arduino shield, using new sensors and trying to avoid having lots of wires floating around.

We bought the 9 DOF stick sensor from sparkfun and the BMP085 barometer (used for altitude hold). When on the  old shield we had the 3 sensors (ADXL345, L3G4200D, HMC588L) on different boards and linked to the shield by  wires, we now have a single breakout board, directly soldered on the shield, which is a much better looking solution. It also avoids long steps of soldering, plugging mistakes etc... The EM406 breakout board is also directly soldered on the shield. We added two 7x2 connectors, in order to plug the RC receiver, SRF02 sonar sensor and possibly 2 servos in order to control a 2 axis gimball 🙂 The schematic looks like this:

The shield schematic

Another novelty of this shield is the connections with LEDs flexible strip. In addition to the aesthetic side, it will also be useful to distinguish the front from the back of the quadcopter, signal the end of calibration, blink during altitude hold mode etc.. These LEDs strip are not directly plugged to the Arduino, since they require 12V input and could be a bit too much power consuming to be fed from the Arduino. So they are controlled by a NPN BC517 transistor of which the base is connected to a digital output  like so:

How to control the LED strip with the Arduino

The last difference with our previous quadcopter is the change from a L3G4200D gyro in SPI mode to a ITG3200 in I²C mode. We did this partly to free all the SPI connections of the Arduino (10-13) because we needed available ports for the LEDs and for the future gimball, and because our L3G4200D was  pretty often giving completely false readings without any reason. We couldn't find the cause of this problem but we found a few people having the same problem  when we googled it... That pushed us to buy this stick sensor.

The final PCB looks like this:

The shield PCB

The holes and the contour were drilled with Benoit's CNC router and after soldering all the parts, the final results looks like this:

The Arduino shield with theEM406 breakout board, the 9 DOF stick IMU, and the BMP085 barometer

We have tried this shield with our old prototype frame and everything works fine, the flight is really stable.We use the LEDs to show the end of calibration and of course to show the front of the aircraft which is a big help when flying.

So as I said in the beginning of this article we are currently building a brand new frame entirely made of carbon fiber, with new motors, new ESCs and new propellers. We hope that we can finish the construction within the month to come (if we receive our order made at Hobbyking 2 weeks ago 🙂 ) and we will of course post pictures on the website! Stay tuned 😉

5 thoughts on “The quadcopter : the flight controller shield

    1. Hi Margot, this is only intended for GPS connection : it uses RX and TX pins from the arduino to communicate with the GPS chip (not shown on the picture). We wanted to use this in order to log our flights and make an autopilot, but we bought recently a ardupilot mega that does this job greatly ! (we made a article about it). We also just bought a cheap multiwii board from HK that we will try soon on a tricopter, and we will make an article about this too if you're interested

Leave a Reply

Your email address will not be published. Required fields are marked *